Applies to: All Zosi NVRs.

Question: Can NVR Connect to the Internet Through a Wireless Bridge?

Answer:

Yes, an NVR (Network Video Recorder) can be connected to the internet through a wireless bridge. Here’s a detailed guide on how to achieve this:

1. What is a Wireless Bridge?

A wireless bridge is a device that connects two or more network segments, allowing data to be transferred wirelessly between them. It effectively converts a wired Ethernet connection to a wireless one.

2. Why Use a Wireless Bridge for NVR?

Using a wireless bridge is useful in situations where running an Ethernet cable directly from the NVR to the router is impractical or impossible due to distance or physical barriers. It provides a flexible and convenient way to connect the NVR to the internet.

3. Requirements for Connecting NVR via Wireless Bridge:

• NVR System: Ensure your NVR system is compatible with network connections.
• Wireless Bridge Device: Purchase a reliable wireless bridge that supports your network’s speed and bandwidth requirements.
• Router with Internet Access: Ensure your router is properly set up and has a stable internet connection.

4. Steps to Connect NVR to the Internet Using a Wireless Bridge:

1. Setup the Wireless Bridge:

   • Connect the Wireless Bridge to Your Computer: Use an Ethernet cable to connect the bridge to your computer for initial setup.
   • Configure the Wireless Bridge: Access the bridge’s setup page through your web browser (usually by entering the device’s IP address). Follow the manufacturer’s instructions to configure the bridge to connect to your wireless network.
   • Disconnect and Place the Bridge: Once configured, disconnect the bridge from your computer and place it near the NVR.

2. Connect the NVR to the Wireless Bridge:

   • Ethernet Connection: Use an Ethernet cable to connect the NVR to the wireless bridge.
   • Power On the Devices: Ensure both the NVR and the wireless bridge are powered on and properly connected.

3. Test the Connection:

   • Check Network Status: Access the NVR’s network settings to verify it has obtained an IP address and is connected to the internet.
   • Monitor and Adjust: Test the connection by accessing the NVR remotely to ensure the video feed is accessible. Adjust the wireless bridge placement if the signal strength is weak.

5. Troubleshooting Tips:

• Signal Strength: Ensure the wireless bridge is within a good range of the router to maintain a strong signal.
• Firmware Updates: Keep the firmware of both the NVR and the wireless bridge up to date to ensure compatibility and security.
• Network Interference: Minimize interference by placing the bridge away from other electronic devices that might cause signal disruption.

Conclusion:

Connecting an NVR to the internet through a wireless bridge is a practical solution when direct wiring is not feasible. By following the steps outlined above, you can ensure a stable and secure connection for your NVR system, enabling remote access and monitoring capabilities.

Note: You can directly hook up the Recorder to the wireless bridge with the lan cable,and the network will  be tested OK.

Advantages of wireless bridge transmission: 1 long transmission distance;

2 Stable transmission signal,;

3 Strong anti-interference,

4 Low cost.

Where does it fit in? Elevators, forests, construction sites, and other places that require complex wiring and long-distance transmission.